PA66 GF33 Filled with Glass Fibre Reinforced 33% GF Nylon66

Polyamide 6,6 , 33% Glass Fibre Rinforced , Injection Moulding Grade

PRODUCTION PROPERTIES

S V33 NC is 33% glass fibre reinforced  PA66 resin ,  specially formulated to combine quality, performance and processability .  It delivers verall balance of strength, stiffness and toughness combined with excellent chemical and abrasion resistance.

TYPICAL APPLICATIONS/ END USES

S V33 NC has been widely used in the automotive industry ,power tool, consumer goods , ourdoor goods parts 

PROCESSING GUIDELINES:

MATERIAL HANDLING :

PA (nylon) materials must be properly dried in order to provide parts with optimum strength and toughness. Nylon materials are hygroscopic and will become degraded by excessive moisture during the injection molding process. Products is supplied in moisture-protected containers and drying prior to molding is not required. If drying becomes necessary, a dehumidifying or desiccant dryer operating at 80 °C is recommended. Drying time is dependent on moisture level, but 4-6 hours is generally sufficient, but final moisture content must be less than 0.2%.

TYPICAL PROFILE :

Melt Temperature :
Feed Zone 265-275 °C Compression Zone 275-290 °C Front Zone 285-295°C
Mold Temperature : 70-90 °C, but temperatures of as low as 45 °C and as high as 105 °C can be used where applicable
Injection Pressure 70-90MPa

FILL RATE:

Fast fill rates are recommended to ensure uniform melt delivery to the cavity and prevent premature freezing. Surface appearance is directly affected by injection rate